SEAT POSITION SENSOR > INSTALLATION |
| 1. INSTALL SEAT POSITION AIRBAG SENSOR |
Using a 1 mm (0.039 in.) feeler gauge, install the seat position sensor.
Using a T30 "torx" socket, tighten the "torx" screw to install the seat position sensor.
Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm to 1.4 mm (0.023 to 0.055 in.).
Connect the connector.
![]() |
Install the seat slide position sensor protector to the seat position sensor.
| 2. INSTALL FRONT SEAT ASSEMBLY (for Manual Seat) |
Place the seat in the cabin.
Connect the connector under the seat.
Lift up the seat track adjusting handle and move the seat to the rearmost position.
![]() |
Install the 2 bolts to the front side of the seat.
Lift up the seat track adjusting handle and move the seat to the foremost position.
![]() |
Install the 2 bolts to the rear side of the seat.
| 3. INSTALL FRONT SEAT ASSEMBLY (for Power Seat) |
Place the seat in the cabin.
Connect the connectors under the seat.
Connect the cable to the negative (-) battery terminal.
![]() |
Operate the power seat switch knob and move the seat to the rearmost position.
Install the 2 bolts to the front side of the seat.
![]() |
Operate the power seat switch knob and move the seat to the foremost position.
Install the 2 bolts to the rear side of the seat.
![]() |
Install the front seat track bracket outer cover in the direction indicated by the arrow in the illustration and attach the 2 claws.
![]() |
Install the front seat track bracket inner cover in the direction indicated by the arrow in the illustration and attach the 2 claws.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).