Home › ENGINE ยท 2AD-FHV › EMISSION CONTROL › DIFFERENTIAL PRESSURE SENSOR

DIFFERENTIAL PRESSURE SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK DIFFERENTIAL PRESSURE SENSOR ASSEMBLY
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Powertrain / Engine / Data List / DPNR Differential Pressure.

  1. Disconnect the vacuum hose from the sensor.



    A206306E01
  1. Using SST, apply pressure to the sensor.

    SST
    09992-00242  

  1. Check the pressure value of the sensor.

    Standard pressure:
    Approximately the same pressure as the applied pressure is indicated on the tester.

    NOTICE:
    Perform the inspection within the range of 0 to 98 kPa (0 to 1.0 kgf/cm2, 0 to 14.2 psi).

    If the result is not as specified, check the sensor circuit (Click here).

  1. Connect the vacuum hose to the sensor.