REAR BRAKE > REASSEMBLY |
| 1. INSTALL REAR DISC |
![]() |
Align the matchmarks and install the disc.
| 2. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG |
Install the adjusting hole plug to the rear disc.
| 3. CHECK DISC RUNOUT |
Check the bearing backlash and axle hub deviation .
Tighten the disc with the 5 hub nuts.
![]() |
Using a dial indicator, measure the disc runout 10 mm (0.39 in.) from the outer edge of the disc.
Remove the 5 hub nuts and disc.
| 4. ADJUST PARKING BRAKE SHOE CLEARANCE |
Temporarily install the hub nuts.
![]() |
Remove the shoe adjusting hole plug, and then turn the adjuster to expand the shoe adjuster until the disc locks.
Turn the shoe adjuster so that it contracts to a point where the disc can rotate smoothly.
Check that the shoe has no brake drag.
| 5. TEMPORARILY INSTALL REAR DISC BRAKE BLEEDER PLUG |
Temporarily install the bleeder plug to the brake cylinder.
Install the bleeder plug cap to the bleeder plug.
| 6. INSTALL PISTON SEAL |
![]() |
Apply a light coat of lithium soap base glycol grease to the entire inner and outer circumference of a new piston seal.
Install the piston seal to the brake cylinder.
| 7. INSTALL REAR DISC BRAKE PISTON |
![]() |
Apply a light coat of lithium soap base glycol grease to the entire inner and outer circumference of a new cylinder boot.
Apply a light coat of lithium soap base glycol grease to the entire outer circumference of the rear disc brake piston where it contacts the rear disc brake cylinder.
Install the cylinder boot to the rear disc brake piston.
Install the rear disc brake piston to the rear disc brake cylinder assembly.
| 8. INSTALL CYLINDER BOOT |
![]() |
Install the cylinder boot to the cylinder.
Using a screwdriver, install a new set ring.
| 9. INSTALL REAR DISC BRAKE BUSH DUST BOOT |
![]() |
Apply a light coat of lithium soap base glycol grease to the entire circumference of a new rear disc brake bush dust boot where it contacts the rear disc brake cylinder mounting, and the entire inner circumference of its both ends.
Install the 2 boots to the mounting.
| 10. INSTALL REAR DISC BRAKE CYLINDER SLIDE BUSH |
![]() |
Apply a light coat of lithium soap base glycol grease to the rear disc brake cylinder slide pin where it contacts rear disc brake cylinder slide bush.
Install the slide bush to the slide pin.
| 11. INSTALL REAR DISC BRAKE CYLINDER SLIDE PIN |
![]() |
Apply lithium soap base glycol grease to the sliding part and the seal surface of the 2 rear disc brake cylinder slide pins.
Install the 2 slide pins (upper and lower) to the mounting.
| 12. INSTALL REAR DISC BRAKE CYLINDER MOUNTING LH |
![]() |
Install the cylinder mounting with the 2 bolts.
| 13. INSTALL REAR DISC BRAKE PAD SUPPORT PLATE |
Install the 2 plates to the mounting.
| 14. INSTALL PAD WEAR INDICATOR PLATE |
Install the 2 indicator plates to the lower side of each pad.
| 15. INSTALL ANTI-SQUEAL SHIM |
![]() |
Apply disc brake grease to both sides of each No. 1 shim.
Install the No. 1 and No. 2 shims to the pads.
| 16. INSTALL REAR DISC BRAKE PAD |
Install the 2 disc brake pads to the mounting.