Home › BODY › EXTERIOR › FRONT DOOR BELT MOULDING

FRONT DOOR BELT MOULDING > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY LH


    B130252
  1. Attach the claws to install the belt moulding.

    HINT:
    Confirm that the moulding is firmly installed.



2. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH


B129405E03
  1. Pass the connector labeled A and wire harness of the mirror through the wire harness hole.

  1. Temporarily install the mirror by inserting the bosses on the mirror into the holes on the vehicle and temporarily installing the 3 screws.

  1. Tighten the 3 screws in the sequence shown in the illustration to install the mirror.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Connect the connector labeled A.



3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
  1. Attach the 4 claws to install the speaker door grille.

  1. Attach the 7 claws to install the weatherstrip inner.



    B133485
  1. Attach the 2 claws to install the inside handle.



    B133484
  1. Attach the 10 clips to install the trim board.

  1. Install the 3 screws.



    B129164
  1. Attach the 3 claws to install the door inside handle bezel plug.



    B133479
  1. Attach the 12 claws to install the door assist grip.



4. INSTALL FRONT ARMREST BASE PANEL UPPER LH


B129161
  1. for Driver Side:
    Install the power window regulator master switch to the panel with the 3 screws.



    B137873
  1. for Passenger Side:
    Attach the 2 claws and install the power window regulator switch to the panel.

  1. Connect the switch connectors.



    B129160
  1. Attach the clip and 5 claws to install the panel (with the switch).



5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH


B129158
  1. Attach the clip and 3 claws to install the garnish.