Home › BODY › EXTERIOR › REAR DOOR BELT MOULDING

REAR DOOR BELT MOULDING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE REAR DOOR ARMREST BASE PANEL UPPER LH


    B130016
  1. Using a screwdriver, detach the clip, 5 claws, and remove the panel (with switch).

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the switch connectors.



    B130015
  1. Using a screwdriver, detach the 2 claws and remove the power window regulator switch from the panel.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Be careful when detaching the claws as the switch may fall and become damaged.



2. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    B130017
  1. Using a screwdriver, detach the 12 claws and remove the door assist grip cover.

    HINT:
    Tape the screwdriver tip before use.



    B129164
  1. Using a screwdriver, detach the 3 claws and remove the door inside handle bezel plug.

    HINT:
    Tape the screwdriver tip before use.



    B137876E01
  1. Remove the 3 screws.

  1. for 8 Clip Type:
    Using a screwdriver, detach the 8 clips, 2 claws and remove the trim.

    HINT:
    1. Tape the screwdriver tip before use.
    2. If the screwdriver cannot reach the clips, pull on the lower trim to remove it.

  1. for 7 Clip Type:
    Using a screwdriver, detach the 7 clips, 2 claws and remove the trim.

    HINT:
    1. Tape the screwdriver tip before use.
    2. If the screwdriver cannot reach the clips, pull on the lower trim to remove it.

  1. Using a screwdriver, detach the 6 claws and remove the weatherstrip inner.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH


    B130254E01
  1. Put protective tape under the belt moulding.

  1. Using a moulding remover, detach the claws to remove the belt moulding as shown in the illustration.

    HINT:
    Tape the remover tip before use.

    NOTICE:
    Be careful when removing the belt moulding as there are claws attached to the front and rear ends of the belt moulding.