Home › ENGINE ยท 2AD-FTV › FUEL › FUEL INJECTOR

FUEL INJECTOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK INJECTOR ASSEMBLY
  1. Start the engine and drive the vehicle until the engine coolant temperature reaches 60°C (140°F) or higher.

  1. Allow the engine to idle for 1 minute or more.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / Injection Volume and Injector Feedback Val. #1 to #4.

  1. Read the values when the engine is idling.

  1. Check that the "Injector Feedback Val. #1 to #4" values are within the specification.

    Standard:

    Tester Display
    Engine Condition
    Specified Condition
    Injection Volume
    Idling
    Less than 10 mm3/st
    Injector Feedback Val. #1
    Injector Feedback Val. #2
    Injector Feedback Val. #3
    Injector Feedback Val. #4
    Idling
    -4.9 to 4.9 mm3/st

    If the result is not as specified, replace the injector assembly.