Home › RESTRAINTS › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY

REAR SEAT OUTER BELT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE REAR DOOR SCUFF PLATE LH (for Short Body)


    B129711
  1. Using a screwdriver, detach the 8 claws and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE REAR DOOR SCUFF PLATE LH (for Long Body)


B129703
  1. Using a screwdriver, detach the 9 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 2 clips and remove the garnish.



4. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH


5. REMOVE PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY


6. REMOVE TONNEAU COVER ASSEMBLY


7. REMOVE REAR FLOOR NO. 1 BOARD


8. REMOVE DECK BOARD ASSEMBLY


9. REMOVE REAR FLOOR NO. 2 BOARD


10. REMOVE REAR FLOOR NO. 3 BOARD


11. REMOVE JACK CARRIER ASSEMBLY (for Short Body)


B129715
  1. Using a clip remover, remove the 7 clips and remove the jack carrier.



12. REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE (for Short Body)


B129717
  1. Remove the 4 screws.

  1. Using a clip remover, detach the 7 clips and remove the plate.



13. REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE (for Long Body)


B129705
  1. Remove the 4 screws.

  1. Using a clip remover, detach the 7 clips and remove the plate.



14. REMOVE BACK DOOR WEATHERSTRIP


15. REMOVE REAR FLOOR FINISH PLATE (for Short Body)


    B129716
  1. Using a clip remover, detach the 6 clips and remove the finish plate.



16. REMOVE REAR FLOOR FINISH PLATE (for Long Body)


B129704
  1. Using a clip remover, detach the 6 clips.

  1. Detach the 2 claws and remove the finish plate.



17. REMOVE RECLINING REMOTE CONTROL LEVER BEZEL LH


18. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER (for Short Body)


19. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET (for Short Body)


20. DISCONNECT REAR NO. 1 SEAT BELT ASSEMBLY OUTER RH


B133643
  1. Remove the lap belt outer anchor cover.

  1. Remove the bolt and disconnect the floor anchor.



21. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for Short Body)


    B137546
  1. Disconnect the rear No. 1 seat belt's floor anchor.

    1. Remove the anchor cover.

    2. Remove the bolt and disconnect the floor anchor.



    B129712
  1. Remove the bolt and 2 screws.

  1. Using a screwdriver, detach the 5 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 5 clips and remove the trim board.

  1. Disconnect the power outlet socket connector.

  1. Remove the belt hanger.



22. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for Long Body)


    B137546
  1. Disconnect the rear No.1 seat outer belt's floor anchor.

    1. Remove the anchor cover.

    2. Remove the bolt and disconnect the floor anchor.



    B129706
  1. Remove the 2 screws and 2 bolts.

  1. Using a screwdriver, detach the 5 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 4 clips and remove the trim board.

  1. Disconnect the power outlet socket connector.

  1. Remove the belt hanger.



23. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH (for Short Body)


    B129714
  1. Using a clip remover, detach the 7 clips and remove the garnish.



24. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH (for Long Body)


    B129708
  1. Using a clip remover, detach the 7 clips and remove the garnish.



25. REMOVE REAR NO. 1 SEAT BELT ASSEMBLY OUTER LH


B133644
  1. Remove the bolt and disconnect the seat belt's shoulder anchor.



    B133645
  1. Remove the 2 bolts and seat belt.