Home › BODY ELECTRICAL › LIGHTING › MAP LIGHT ASSEMBLY

MAP LIGHT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT MAP LIGHT ASSEMBLY


E073293E01
  1. Inspect the map light.

    1. Connect the battery's positive (+) lead to terminal 6 and the negative (-) lead to terminal 1, and then check that the light comes on when the switch is in the DOOR position.

      OK:
      Light comes on.

      If the result is not as specified, replace the light assembly.

    2. Connect the battery's positive (+) lead to terminal 6 and the negative (-) lead to terminal 7, and then check that the light comes on when the switch is in the ON position.

      OK:
      Light comes on.

      If the result is not as specified, replace the light assembly.