Home › BODY ELECTRICAL › LIGHTING › MAP LIGHT ASSEMBLY

MAP LIGHT ASSEMBLY > REMOVAL

for Preparation Click here




1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE MAP LIGHT ASSEMBLY


B131951
  1. Detach the 4 clips and remove the map light.

  1. Disconnect the light connector.



3. REMOVE MAP LIGHT LENS


B131467
  1. Using a screwdriver, pry out the 8 claws and remove the map light lens.

    HINT:
    Tape the screwdriver tip before use.