Home › BODY ELECTRICAL › WIPER AND WASHER › REAR WIPER MOTOR

REAR WIPER MOTOR > INSTALLATION

for Preparation Click here



1. INSTALL REAR WIPER MOTOR ASSEMBLY


B131460
  1. Install the wiper motor with the 3 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the connector.



2. INSTALL REAR WIPER MOTOR GROMMET


3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY
  1. Stop the wiper motor at the automatic stop position.



    B117856E02
  1. Clean the wiper arm serration with a round file or equivalent.

  1. Clean the wiper pivot serration with a wire brush.



    E125268E03
  1. Install the arm and blade with the nut. Make sure that the arm and blade comes to the position shown in the illustration.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    HINT:
    1. Hold down the arm hinge by hand while tightening the nut.
    2. Install the arm and blade so that the rear wiper blade is aligned with the defogger line.



    B136379
  1. Install the cap.



4. INSTALL BACK DOOR TRIM BOARD ASSEMBLY
  1. Install the back door trim pocket with the 5 screws.



    B129943
  1. Attach the 13 clips to install the trim board.



5. INSTALL BACK DOOR SIDE GARNISH LH


    B129945
  1. Attach the 2 claws and 2 clips to install the garnish.



6. INSTALL BACK DOOR SIDE GARNISH RH

HINT:
Use the same procedure described for the LH side.



7. INSTALL BACK DOOR CENTER GARNISH


    B129944
  1. Attach the 4 claws and 4 clips to install the garnish.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL