DTC B1421/21 Solar Sensor Circuit (Passenger Side) |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1421/21 | Open or short in passenger side solar sensor circuit |
|

| 1.READ VALUE USING INTELLIGENT TESTER (SOLAR SENS-P) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester main switch ON.
Select the item below in the Data List, and read the value displayed on the intelligent tester.
| Item | Measure Item / Display (Range) | Normal Condition | Diagnostic Note |
| Solar Sens-P | Passenger side solar sensor / Min.: 0, Max.: 255 | Passenger side temperature increases as brightness increases | - |
| Result | Proceed to |
| NG | A |
| OK (Checking from the PROBLEM SYMPTOMS TABLE) | B |
| OK (Checking from the DTC) | C |
|
| ||||
|
| ||||
| A | |
| 2.INSPECT SOLAR SENSOR |
![]() |
Remove the solar sensor.
Measure the resistance of the sensor.
Connect the positive (+) lead from the ohmmeter to terminal 1 and the negative (-) lead to terminal 2 of the solar sensor.
| Tester Connection | Condition | Specified Condition |
| 1 (SS) - 2 (TSP) | Sensor exposed to electric light | Except ∞ Ω |
| 1 (SS) - 2 (TSP) | Sensor covered with cloth | ∞ Ω (No continuity) |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (SOLAR SENSOR - AIR CONDITIONING AMPLIFIER) |
![]() |
Disconnect the F1 sensor connector.
Disconnect the E41 amplifier connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E41-32 (TSP) - F1-2 (TSP) | Below 1 Ω |
| E41-31 (S5-4) - F1-1 (SS) | Below 1 Ω |
| E41-32 (TSP) - Body ground | 1 MΩ or higher |
| E41-31 (S5-4) - Body ground | 1 MΩ or higher |
|
| ||||
| OK | ||
| ||