BRAKE BOOSTER (for RHD) > REMOVAL |
| 1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY |
Remove the windshield wiper motor and link assembly (Click here).
| 2. REMOVE COWL VENTILATOR HOUSING SUB-ASSEMBLY |
![]() |
Disengage the 4 clips and remove the cowl ventilator housing sub-assembly.
| 3. REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY |
![]() |
Disconnect the connector.
Remove the 14 bolts and cowl top panel outer sub-assembly.
| 4. REMOVE COWL BODY MOUNTING REINFORCEMENT RH |
![]() |
Remove the 2 nuts and cowl body mounting reinforcement RH.
| 5. DRAIN BRAKE FLUID |
| 6. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY |
![]() |
Release the vacuum pressure in the brake booster as follows.
Stop the engine.
Depress the brake pedal several times.
for Manual Transaxle:
Disconnect the clutch reservoir tube labeled A from the master cylinder.
Disconnect the brake fluid level warning switch connector labeled B.
Using a union nut wrench, disconnect the 2 brake lines labeled C from the master cylinder.
Remove the 2 nuts.
![]() |
Pull out the master cylinder from the brake booster.
Remove the O-ring from the master cylinder.
| 7. DISCONNECT VACUUM HOSE |
| 8. REMOVE PUSH ROD PIN |
Remove the clip from the push rod pin.
Remove the push rod pin from the push rod clevis.
| 9. REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS |
Loosen the push rod clevis lock nut.
Remove the push rod clevis.
| 10. REMOVE BRAKE BOOSTER ASSEMBLY |
![]() |
Remove the 4 nuts.
Pull out the booster with gasket.
| 11. REMOVE BRAKE BOOSTER GASKET |
| 12. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY |
| 13. REMOVE CHECK VALVE GROMMET |