AIR CONDITIONING PANEL (for Manual Air Conditioning System) > INSTALLATION |
| 1. INSTALL AIR VENT MODE CONTROL SWITCH |
Attach the 2 claws to install the mode control switch.
| 2. INSTALL BLOWER CONTROL SWITCH |
Attach the 2 claws to install the blower control switch.
| 3. INSTALL AIR MIX CONTROL SWITCH |
Attach the 2 claws to install the air mix control switch.
| 4. INSTALL AIR CONDITIONING CONTROL ASSEMBLY |
![]() |
Connect the connectors.
Attach the 3 clips to install the air conditioning control.
Install the 2 screws.
| 5. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System for DVD) |
for 2AD-FTV, 2AD-FHV:
Connect all the connectors to install the navigation receiver.
Insert the navigation receiver to attach the 2 claws and 4 clips on its backside.
Install the 4 bolts.

except 2AD-FTV, 2AD-FHV:
Connect all the connectors to install the navigation receiver.
Insert the navigation receiver to attach the 2 claws and 4 clips on its backside.
Install the 4 bolts.

| 6. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System for HDD) |
Connect all connectors to install the navigation receiver.
Insert the navigation receiver to attach the 2 claws and 4 clips on its backside.
Install the 4 bolts.

| 7. INSTALL STEREO OPENING COVER (w/o Radio Receiver) |
![]() |
Attach the 4 clips to install the stereo opening cover.
Install the 4 bolts.
| 8. INSTALL RADIO RECEIVER ASSEMBLY (w/ Radio Receiver) |
w/o Stereo Opening Cover:
Connect all the connectors and install the radio receiver.
Insert the radio receiver to attach the 2 claws and 4 clips on its backside.
Install the 4 bolts.

w/ Stereo Opening Cover:
Connect all the connectors and install the radio receiver.
Insert the radio receiver to attach the 2 claws and 4 clips on its backside.
Install the 4 bolts.

| 9. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL CENTER |
![]() |
Connect the connector.
Attach the 3 clips and 2 claws to install the cluster finish panel.
| 10. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL CENTER |
![]() |
Connect the connector.
Attach the 3 clips and 2 claws to install the cluster finish panel.
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 12. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).