Home › BODY › SLIDING ROOF › SLIDING ROOF HOUSING

SLIDING ROOF HOUSING > DISASSEMBLY

for Preparation Click here



1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


B125921
  1. Remove the claw and room light bracket.



    B125922
  1. Remove the 2 bolts and drive gear.



2. REMOVE SLIDING ROOF DRAIN HOSE JOINT LH


B129369
  1. Remove the screw and joint.



3. REMOVE SLIDING ROOF DRAIN HOSE JOINT RH

HINT:
Use the same procedures described for the LH side.



4. REMOVE SUNSHADE TRIM SUB-ASSEMBLY


B133638
  1. Slide and remove the sunshade trim.



5. REMOVE SLIDING ROOF DRIVE CABLE


B125928

NOTICE:
Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.

  1. Remove the 2 screws and 2 sliding roof side stoppers.



    B125930
  1. Using a screwdriver, detach the 2 claws. Then slide the drip channel rearward to remove it.

    HINT:
    Tape the screwdriver tip before use.



    B129375
  1. Using a screwdriver, slide the drive cables backward and remove them.

    HINT:
    1. Tape the screwdriver tip before use.