Home › BODY › SLIDING ROOF › SLIDING ROOF HOUSING

SLIDING ROOF HOUSING > REASSEMBLY

for Preparation Click here



1. INSTALL SLIDING ROOF DRIVE CABLE


B122192
  1. Using a screwdriver, slide the sliding roof drive cable sub-assemblies in the direction indicated by the arrow in the illustration to install them.

    HINT:
    Tape the screwdriver tip before use.



    B131978
  1. Engage the 2 claws and install the sliding roof drip channel.



    B125928
  1. Install the 2 sliding roof side stoppers with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }



2. ADJUST FULLY CLOSED POSITION


B084654E02
  1. Using a screwdriver, slide the sliding roof drive cable LH and RH to align the matchmarks.

    HINT:
    Tape the screwdriver tip before use.



3. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


B133638E01
  1. Insert the sunshade trim into the sliding roof housing.



4. INSTALL SLIDING ROOF DRAIN HOSE JOINT LH


B129369
  1. Install the joint with the screw.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }



5. INSTALL SLIDING ROOF DRAIN HOSE JOINT RH

HINT:
Use the same procedures described for the LH side.



6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


B125922
  1. Install the drive gear with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



    B125921
  1. Attach the claw and install the sliding roof drive gear bracket.