Home › BODY › SLIDING ROOF › SLIDING ROOF SWITCH ASSEMBLY

SLIDING ROOF SWITCH ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT MAP LIGHT ASSEMBLY


    E164298E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    8 (UP) - 7 (GND)
    TILT UP switch pushed
    Below 1 Ω
    8 (UP) - 7 (GND)
    TILT UP switch not pushed
    10 kΩ or higher
    9 (DOWN) - 7 (GND)
    SLIDE OPEN switch pushed
    Below 1 Ω
    9 (DOWN) - 7 (GND)
    SLIDE OPEN switch not pushed
    10 kΩ or higher

    If the result is not as specified, replace the map light assembly.