Home › ENGINE · 2AD-FTV › FUEL › FUEL FILTER

FUEL FILTER > INSPECTION

for Preparation Click here



1. INSPECT LEVEL WARNING SWITCH


    A114909E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Float upper end position
    Below 1 Ω
    1 - 2
    Float lower end position
    10 kΩ or higher

    Text in Illustration 
    *1
    Component without harness connected
    (Level Warning Switch)
    If the result is not as specified, replace the level warning switch.