Home › ENGINE · 2AD-FHV › FUEL › COMMON RAIL

COMMON RAIL > INSPECTION

for Preparation Click here



1. INSPECT COMMON RAIL ASSEMBLY


    A114886E07
  1. Inspect the fuel pressure sensor.

    1. Measure the resistance according to the value(s) in the table below.

      HINT:
      Perform the inspection with no fuel pressure applied.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      5 (PR) - 4 (E2)
      Always
      16.4 kΩ or less
      2 (PR2) - 3 (E2S)
      Always
      16.4 kΩ or less
      6 (VC) - 5 (PR)
      Always
      3 kΩ or less
      1 (VCS) - 2 (PR2)
      Always
      3 kΩ or less

      Text in Illustration 
      *1
      Component without harness connected
      (Fuel Pressure Sensor)
      If the result is not as specified, replace the common rail assembly.



    A204352E05
  1. Inspect the pressure discharge valve.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      0.96 to 1.16 Ω

      Text in Illustration 
      *1
      Component without harness connected
      (Pressure Discharge Valve)

      HINT:
      The temperature indicated in "Condition" is the temperature of the pressure discharge valve.
      If the result is not as specified, replace the common rail assembly.