Home › ENGINE ยท 2AD-FTV › CHARGING › CHARGING SYSTEM

CHARGING SYSTEM > Charge Warning Light Comes ON while Driving

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK GENERATOR PULLEY WITH CLUTCH (LOCK FUNCTION)
  1. Check the lock function with the pulley installed in the vehicle.

    1. Visually check that the rotor in the generator operates with the engine started.



  1. Check the lock function with the pulley removed from the vehicle.

    1. Remove the pulley cap. Using SST, hold the generator rotor.



    2. A196799E03
    3. Turn the pulley clockwise and check that the outer ring locks.
      Text in Illustration 
      *1
      Free
      *2
      Lock

      OK:
      The outer ring locks.

SST
09820-63021  


NG
REPLACE GENERATOR PULLEY WITH CLUTCH
OK


2.CHECK GENERATOR PULLEY WITH CLUTCH (LOCK)
  1. Start the engine and visually check looseness of the pulley.

    OK:
    The pulley is not loose.



NG
TIGHTEN GENERATOR PULLEY WITH CLUTCH TO SPECIFIED TORQUE
OK

REPLACE GENERATOR ASSEMBLY