Home › ENGINE ยท 2AD-FTV › CHARGING › CHARGING SYSTEM

CHARGING SYSTEM > Noise Occurs from Generator while Engine is Running

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK FAN AND GENERATOR V BELT (LOOSENESS)
  1. Check the tension of the belt by pushing it down with a finger.

    OK:
    The tension of the belt is sufficient.



NG
REPLACE V-RIBBED BELT TENSIONER ASSEMBLY
OK


2.CHECK FAN AND GENERATOR V BELT (FOR WEAR)
  1. Check the V belt for wear.

    OK:
    The V belt is not worn.



NG
REPLACE FAN AND GENERATOR V BELT
OK


3.CHECK GENERATOR PULLEY WITH CLUTCH (FOR WEAR)
  1. Check the pulley groove for wear or other defects.

    OK:
    The pulley groove is not damaged.



NG
REPLACE GENERATOR PULLEY WITH CLUTCH
OK


4.CHECK FOR NOISE WHILE GENERATOR PULLEY WITH CLUTCH IS OPERATING
  1. Perform a driving test and check if noise occurs when decelerating.

    OK:
    Noise does not occur.



NG
REPLACE GENERATOR PULLEY WITH CLUTCH
OK

REPLACE GENERATOR ASSEMBLY