Home › BODY › WINDSHIELD / WINDOWGLASS › WINDSHIELD DEICER RELAY

WINDSHIELD DEICER RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE WINDSHIELD DEICER RELAY (Marking: DEICER)
  1. Remove the defogger relay from the engine room No. 2 relay block.



2. INSPECT WINDSHIELD DEICER RELAY


B060778E04
  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.



3. INSTALL WINDSHIELD DEICER RELAY