Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT LEVELING SWITCH

HEADLIGHT LEVELING SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE NO. 1 SWITCH HOLE BASE


B208358
  1. Using a screwdriver, detach the 4 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connectors and remove the switch hole base.



3. REMOVE HEADLIGHT LEVELING SWITCH


B131428
  1. Detach the 2 claws and remove the headlight leveling switch.