Home › BODY › SEAT › SEAT HEATER SWITCH

SEAT HEATER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SEAT HEATER SWITCH


    B131373E01
  1. Measure the resistance of the seat heater switch when the switch is operated.

    Standard resistance:
    for LH 
    Tester Connection
    Switch Condition
    Specified Condition
    5 (IG) - 6 (LH)
    ON
    Below 1 Ω
    5 (IG) - 6 (LH)
    OFF
    10 kΩ or higher
    for RH 
    Tester Connection
    Switch Condition
    Specified Condition
    4 (IG) - 3 (RH)
    ON
    Below 1 Ω
    4 (IG) - 3 (RH)
    OFF
    10 kΩ or higher

    If the result is not as specified, replace the switch.



    B131375E01
  1. Check that the seat heater switch indicator light illuminates when the switch is operated.

    OK:
    for LH 
    Measurement Connection
    Switch Condition
    Specified Condition
    Battery positive (+) → 5 (IG)
    Battery negative (-) → 2 (E)
    ON
    Illuminates
    for RH 
    Measurement Connection
    Switch Condition
    Specified Condition
    Battery positive (+) → 4 (IG)
    Battery negative (-) → 2 (E)
    ON
    Illuminates

    If the result is not as specified, replace the switch.



    B131374
  1. Check that the seat heater switch illuminates.

    OK:
    Measurement Connection
    Switch Condition
    Specified Condition
    Battery positive (+) → 7
    Battery negative (-) → 8
    Always
    Illuminates

    If the result is not as specified, replace the switch.