DTC B1249 Double Locking ECU Communication Stop |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1249 | No communication from double door lock ECU for more than 10 seconds |
|

| 1.READ VALUE USING INTELLIGENT TESTER (COMMUNICATION DOUBLE LOCKING) |
Check the Data List to ensure the proper operation of the double door lock ECU.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| Communication Double Locking | Connection status between double door lock ECU and main body ECU / OK or STOP | OK: Connection STOP: No connection | - |
|
| ||||
| NG | |
| 2.CHECK WIRE HARNESS (DOUBLE DOOR LOCK ECU - BODY ECU, BATTERY AND BODY GROUND) |
![]() |
Disconnect the E82 double door lock ECU connector.
Disconnect the E18 main body ECU connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E82-9 (MPX1) - E18-23 (LIN2) | Below 1 Ω |
| E82-9 (MPX1) or E18-23 (LIN2) - Body ground | 10 kΩ or higher |
| E82-14 (GND) - Body ground | Below 1 Ω |
Measure the voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
| E82-1 (+B) - Body ground | 10 to 14 V |
|
| ||||
| OK | ||
| ||