Home › BRAKE › PARKING BRAKE › PARKING BRAKE ASSEMBLY

PARKING BRAKE ASSEMBLY > INSPECTION

for Preparation Click here



1. CHECK BRAKE DISC INSIDE DIAMETER


    C127308
  1. Using a drum gauge or equivalent, measure the inside diameter of the disc.

    Standard inside diameter:
    172 mm (6.77 in.)

    Maximum inside diameter:
    173 mm (6.81 in.)

    If the inside diameter is greater than the maximum, replace the disc.



2. CHECK PARKING BRAKE SHOE LINING THICKNESS


    C127307
  1. Using a ruler, measure the shoe lining thickness.

    Standard thickness:
    3.5 mm (0.138 in.)

    Minimum thickness:
    1.0 mm (0.039 in.)

    If the shoe lining thickness is equal to or less than the minimum, replace the brake shoe assembly.



3. CHECK BRAKE DISC AND PARKING BRAKE SHOE LINING FOR PROPER CONTACT


    C127309
  1. Apply chalk to the inside surface of the disc. Touch the brake shoe to the disc and check that there is full contact between the brake shoe and disc (white chalk is transferred to the entire brake shoe).
    If the contact is not as specified, use a shoe grinder to repair the brake shoe, or replace the brake shoe assembly.