PARKING BRAKE ASSEMBLY > DISASSEMBLY |
| 1. REMOVE REAR WHEEL |
| 2. DISCONNECT REAR DISC BRAKE CYLINDER MOUNTING LH |
![]() |
Remove the 2 bolts and cylinder mounting.
| 3. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG |
Remove the shoe adjusting hole plug from the rear disc.
| 4. REMOVE REAR DISC |
![]() |
Put matchmarks on the disc and axle hub.
Release the parking brake.
![]() |
Turn the shoe adjuster until the disc turns freely, and then remove the disc.
Install the shoe adjusting hole plug to the disc.
| 5. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Upper Side) |
![]() |
Using needle-nose pliers, remove the 2 shoe return tension springs.
| 6. REMOVE PARKING BRAKE SHOE STRUT LH |
| 7. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Lower Side) |
Using needle-nose pliers, remove the tension spring.
| 8. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET |
Remove the screw set.
| 9. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH |
![]() |
Press the shoe hold-down spring to remove the pin, shoe hold-down spring and shoe.
| 10. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH |
![]() |
Slide the shoe to remove the shoe hold-down spring, pin and shoe.
Disconnect the parking brake cable from the parking brake shoe lever.
| 11. REMOVE PARKING BRAKE SHOE LEVER LH |