AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > Back-up Power Source Circuit |

| 1.INSPECT FUSE (ECU-B2) |
Remove the ECU-B2 fuse from the engine room No. 2 relay block.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (AIR CONDITIONING AMPLIFIER - BATTERY) |
![]() |
Disconnect the E41 amplifier connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
| E41-21 (B) - Body ground | 10 to 14 V |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (AIR CONDITIONING AMPLIFIER - BODY GROUND) |
![]() |
Disconnect the E41 amplifier connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| E41-14 (GND) - Body ground | Below 1 Ω |
|
| ||||
| OK | ||
| ||