DTC B2321 Driver Side Door ECU Communication Stop |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2321 | No communication from power window regulator motor (driver side) for more than 10 seconds |
|

| 1.CHECK WHETHER DTC OUTPUT RECURS (DTC B2321) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Clear the DTCs.
Select the following menu items: Body / Body ECU / DTC.
Result DTCs.
| Display (DTC Output) | Proceed to |
| B2321 | A |
| No DTC output | B |
|
| ||||
| A | |
| 2.READ VALUE USING INTELLIGENT TESTER (COMMUNICATION D DOOR MOTOR) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Body / Body ECU / Data List / Comm D-Door Mtr.
Read the result displayed on the tester.
| Item | Measurement Item / Display (Range) | Normal Condition |
| Communication D-Door Motor | Connection status between power window regulator motor assembly (driver door) and main body ECU / OK or Stop | OK: Connection Stop: No connection |
|
| ||||
| NG | |
| 3.CHECK WIRE HARNESS (MAIN BODY ECU - REGULATOR MOTOR) |
![]() |
Disconnect the H4*1 or G9*2 motor connector.
Disconnect the E18 junction block connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| H4-9 (LIN) - E18-23 (LIN2) | Below 1 Ω |
| H4-9 (LIN) or E18-23 (LIN2) - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| G9-9 (LIN) - E18-23 (LIN2) | Below 1 Ω |
| G9-9 (LIN) or E18-23 (LIN2) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK WHETHER DTC OUTPUT RECURS (DTC B2321) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Clear the DTCs.
Check whether DTC B2321 recurs 10 seconds or more after the ignition switch is turned on (IG).
|
| ||||
| OK | ||
| ||