CRUISE CONTROL MAIN SWITCH (for Torx Type) > INSTALLATION |
| 1. INSTALL CRUISE CONTROL MAIN SWITCH |
![]() |
Install the switch with the 2 screws.
Connect the connector.
| 2. INSTALL STEERING PAD ASSEMBLY |
![]() |
Support the steering pad with one hand as shown in the illustration.
Connect the 2 airbag connectors.
Connect the horn connector.
Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.
![]() |
Using a T30 "torx" driver, install the 2 screws.
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).