Home › BODY › INSTRUMENT PANEL › LOWER INSTRUMENT PANEL

LOWER INSTRUMENT PANEL > DISASSEMBLY

for Preparation Click here



1. REMOVE GLOVE COMPARTMENT DOOR STOPPER SUB-ASSEMBLY


2. REMOVE FUSE BOX OPENING COVER


    B208368
  1. Detach the 2 claws and 2 clips, and then remove the cover.



3. REMOVE INSTRUMENT PANEL SAFETY PAD COVER (w/o Entry and Start System)


    B219392
  1. Using a screwdriver, detach the 4 claws and remove the instrument panel safety pad cover.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE INSTRUMENT PANEL SAFETY PAD COVER (w/ Entry and Start System)


    B210295
  1. Using a screwdriver, detach the 4 claws and remove the instrument panel safety pad cover.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE COOLER (ROOM TEMP. SENSOR) THERMISTOR (for Automatic Air Conditioning System)


    B208370
  1. Detach the 2 claws and remove the cooler thermistor.



6. REMOVE NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY (w/ Illumination)


    B208372
  1. Detach the 2 claws and remove the interior illumination light.



7. REMOVE NO. 2 INTERIOR ILLUMINATION LIGHT ASSEMBLY (w/ Illumination)


    B208369
  1. Rotate the lights in the direction shown in the illustration, disconnect the 4 wire harness clamps and remove the interior illumination light.



8. REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY


    B208371
  1. Detach the 4 wire harness clamps and remove the antenna cord.