ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System) > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the tester ON.
Select the following menu items: Body / Entry&Start / Data List.
Check the results by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Ignition Switch | Engine switch on (IG) signal / ON or OFF | ON: Engine switch on (ACC, IG) or start OFF: Engine switch off | - |
| ACC Switch | Engine switch on (ACC) signal / ON or OFF | ON: Engine switch on (ACC, IG) or start OFF: Engine switch off | - |
| ID-BOX Sleep Condition | ID code box sleep condition / YES or NO | - | - |
| ID-BOX Start Condition | ID code box wake up signal / YES or NO | - | - |
| EFI Code Receive | SFI code receive / OK or NG | OK: ECD code is received NG: ECD code is not received | - |
| Engine Start Request | ID code box start request condition / OK or NG | OK: Start request condition signal is received NG: Start request condition signal is not received | - |
| 3bit Code Request | 3 bit code request / OK or NG | OK: 3 bit code is received NG: 3 bit code is not received | - |
| S Code Check | Code verification result / OK or NG | OK: Verification confirmed NG: Verification is not confirmed | - |
| L Code Check | Code verification result / OK or NG | OK: Verification confirmed NG: Verification is not confirmed | - |