Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System)

DTC    B278A    Short to GND in Immobiliser System Power Source Circuit

for Preparation Click here


DESCRIPTION

This DTC is output when the engine switch power source supply line is open or short.

DTC Code
DTC Detection Condition
Trouble Area
B278A
Engine switch power source supply line is open or short
  1. Wire harness
  2. Engine switch
  3. ECU aggregation box (certification ECU)

WIRING DIAGRAM


B121684E10


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (CERTIFICATION ECU - ENGINE SWITCH)

B108731E07

  1. Disconnect the E63 ECU connector.

  1. Disconnect the E31 switch connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E63-30 (VC5) - E31-14 (VC5)
    Below 1 Ω
    E63-40 (AGND) - E31-8 (AGND)
    E63-30 (VC5) or E31-14 (VC5) - Body ground
    10 kΩ or higher
    E63-40 (AGND) or E31-8 (AGND) - Body ground



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.CHECK ENGINE SWITCH (OPERATION)
  1. Temporarily replace the engine switch with a new or normally functioning one.

  1. Check that the engine starts normally.

    OK:
    Engine starts normally.



NG
REPLACE ECU AGGREGATION BOX (CERTIFICATION ECU)
OK

END (ENGINE SWITCH IS DEFECTIVE)