OIL PUMP > INSPECTION |
| 1. INSPECT OIL PUMP RELIEF VALVE |
Coat the relief valve with engine oil.
![]() |
Check that the relief valve falls smoothly into the valve hole by its own weight.
If the relief valve does not fall smoothly, replace it. If necessary, replace the oil pump relief valve.
| 2. INSPECT OIL PUMP |
![]() |
Install the drive and driven rotors to the timing chain cover with the marks of the rotors facing the cylinder block side. Check that the rotors revolve smoothly.
| *1 | Mark |
![]() |
Check the tip clearance.
Using a feeler gauge, measure the clearance between the drive and driven rotor tips.
![]() |
Check the body clearance.
Using a feeler gauge, measure the clearance between the oil pump body and driven rotor.
![]() |
Check the side clearance.
Using a feeler gauge and precision straightedge, measure the clearance between the rotors and precision straightedge.