Home › ENGINE ยท 2AD-FTV › ENGINE CONTROL SYSTEM › ECM

ECM > INSTALLATION

for Preparation Click here



1. INSTALL ECM


    A124573
  1. Install the 2 ECM brackets with the 4 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }



    A124572
  1. Connect the 2 ECM connectors.

    1. Connect the 2 connectors to the ECM and lower the 2 levers.

      NOTICE:
      Make sure that the 2 levers are securely lowered.



    A124570
  1. Install the ECM with the 3 bolts.

    Torque:
    6.5 N*m{ 66 kgf*cm , 57 in.*lbf }



2. INSTALL AIR CLEANER CASE


    A208831
  1. Attach the clamp and install the air cleaner case with the 3 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



3. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY


A208843E01
  1. Connect the air cleaner hose.

  1. Attach the 3 clips to install the air cleaner cap.

  1. Connect the PCV hose.

    HINT:
    The direction of the hose clamp is indicated in the illustration.

  1. Attach the clamp and connect the mass air flow meter connector.



5. INSTALL NO. 1 ENGINE COVER


    A203808
  1. Attach the 4 clips to install the engine cover.



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


7. PERFORM REGISTRATION
  1. w/ Cruise Control System:
    When replacing the ECM, perform vehicle stability control system recognition in ECM (Click here).

  1. for CCo:
    Perform learning values write .

  1. for DPF:
    Perform learning values write .



8. PERFORM INITIALIZATION
  1. for CCo:
    Perform the supply pump initialization procedure (Click here).

  1. for DPF:
    Perform the supply pump initialization procedure (Click here).



9. PERFORM THROTTLE VALVE FULLY CLOSED POSITION LEARNING

HINT:
Be sure to turn off the ignition switch before performing this inspection.

  1. Turn the ignition switch to ON.

  1. Turn the ignition switch off and wait 10 seconds.

    HINT:
    The fully closed position of the diesel throttle valve is learned when the ignition switch is turned off.