Home › ENGINE ยท 2AD-FTV › ENGINE CONTROL SYSTEM › ECM

ECM > REMOVAL

for Preparation Click here



1. PERFORM REGISTRATION
  1. for CCo:
    Perform learning values save .

  1. for DPF:
    Perform learning values save .



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



3. REMOVE NO. 1 ENGINE COVER


    A203808
  1. Detach the 4 clips and remove the engine cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.



4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A208830
  1. Detach the clamp and disconnect the mass air flow meter connector.

  1. Disconnect the PCV hose.

  1. Disconnect the air cleaner hose.

  1. Detach the 3 clips and remove the air cleaner cap.



5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


6. REMOVE AIR CLEANER CASE


    A208831
  1. Detach the clamp.

  1. Remove the 3 bolts and air cleaner case.



7. REMOVE ECM


    A124570
  1. Remove the 3 bolts holding the ECM brackets.



    A124571E02
  1. Disconnect the 2 ECM connectors.

    1. Raise the 2 levers while pushing the locks on the 2 levers and remove the 2 ECM connectors.

  1. Remove the ECM.



    A124573
  1. Remove the 4 screws and 2 ECM brackets.