STEERING LOCK SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and press the intelligent tester main switch ON.
Read the Data List by following the directions on the tester screen.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Sensor Value | Sensor malfunction / NG (Past) or OK | NG (Past): Sensor malfunction OK: No malfunction | - |
| Power Supply Short | Short in ECU / NG (Past) or OK | NG (Past): Short in ECU OK: No malfunction | - |
| Power Supply Open | Open in ECU / NG (Past) or OK | NG (Past): Open in ECU OK: No malfunction | - |
| Motor Driver Short | Short in driver ECU / NG (Past) or OK | NG (Past): Short in driver ECU OK: No malfunction | - |
| Motor Driver Open | Open in driver ECU / NG (Past) or OK | NG (Past): Open in driver ECU OK: No malfunction | - |
| Lock / Unlock Receive | Steering lock command reception record / YES or NO | YES: Steering lock / unlock signal received NO: Steering lock / unlock signal not received | - |
| Lock Bar Stuck Error | Lock bar stuck malfunction / NG (Past) or OK | NG (Past): Lock bar stuck malfunction OK: No malfunction | - |
| Push Start Error | Push button start function malfunction / NG (Past) or OK | NG (Past): Malfunction in push button start OK: No malfunction | - |
| IG2 Status | IG2 voltage / ON or OFF | ON: 11 to 14 V OFF: Below 1 V | - |
| IG (Lin) | LIN bus start-up status / ON or OFF | ON: LIN bus started-up OFF: LIN bus not started-up | - |
| S Code Check | S code match record / NG or OK | NG: S code not matched OK: S code matched | - |
| L Code Check | L code match record / NG or OK | NG: L code not matched OK: L code matched | - |
| Unlock Request Receive | Steering lock unlock command reception status NG or OK | NG: Unlock request not received OK: Unlock request received | - |
| Lock Request Receive | Steering lock lock command reception status NG or OK | NG: Lock request not received OK: Lock request received | - |
| S Code Check (Past) | S code match record / NG (Past) or OK | NG (Past): S code not matched OK: S code matched | - |
| L Code Check (Past) | L code match record / NG (Past) or OK | NG (Past): L code not matched OK: L code matched | - |