DTC B2782 Power Source Control ECU Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2782 | IGE power supply circuit malfunction |
|

| 1.CHECK DTC (CERTIFICATION ECU) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and press the intelligent tester main switch ON.
Read the DTCs of the certification ECU by following the prompts displayed on the intelligent tester.
|
| ||||
| OK | |
| 2.CHECK STEERING LOCK ACTUATOR ASSEMBLY |
![]() |
Measure the voltage of the steering lock actuator.
| Tester Connection | Condition | Specified Condition |
| E6-3 (IGE) - E6-2 (SGND) | Turn the engine switch on (IG) (When steering lock motor is activating) | Below 1 V |
| Engine switch on (IG) (When steering lock motor is stopped) | 11 to 14 V |
|
| ||||
| NG | |
| 3.CHECK WIRE HARNESS (STEERING LOCK ACTUATOR - BODY GROUND) |
![]() |
Disconnect the E6 steering lock actuator connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| E6-2 (SGND) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (STEERING LOCK ACTUATOR - MAIN BODY ECU) |
![]() |
Disconnect the E6 steering lock actuator connector.
Disconnect the E18 main body ECU connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E6-3 (IGE) - E18-7 (SLR+) | Below 1 Ω |
| E6-3 (IGE) or E18-7 (SLR+) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||