Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Theft Warning Siren Circuit


DESCRIPTION

The theft warning siren has an internal battery. If the vehicle's battery or any of the communication lines is open, the theft warning siren detects it by itself and sounds. Although the theft warning siren usually sounds by receiving a signal from the theft warning ECU, the theft warning siren can sound by its internal battery in case the vehicle's battery is open.
The theft warning ECU sends an arming signal to the theft warning siren while transferring to the armed state, and it also sends a disarming signal to the siren while switching to the disarmed state. Also, the theft warning ECU can cause the theft warning siren to sound by sending an alarm signal during the alarm sounding state.

WIRING DIAGRAM


B132482E01


INSPECTION PROCEDURE

1.CHECK THEFT WARNING SIREN ASSEMBLY
B108840E04


  1. Measure the voltage of the siren.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    L17-1 (+B) - Body ground
    Always
    10 to 14 V
    L17-2 (GND) - Body ground
    Always
    Below 1 V
    L17-3 (CONT) - Body ground
    When switched from armed state or arming preparation state to disarmed state (1)
    Wave pattern (1) shown in chart
    When switched from arming preparation state to disarmed state (2)
    Wave pattern (2) shown in chart
    Normal Condition
    Approx. 1. 4 V


    B108841E02



NG
REPLACE THEFT WARNING SIREN
OK


2.CHECK WIRE HARNESS (THEFT WARNING ECU - THEFT WARNING SIREN)
B133009E01
  1. Disconnect the E83 ECU connector.

  1. Disconnect the L17 siren connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E83-28 (CTLS) - L17-3 (CONT)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK WIRE HARNESS (THEFT WARNING SIREN - BODY GROUND)
B108843E03
  1. Disconnect the L17 siren connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    L17-2 (GND) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE THEFT WARNING ECU