Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > DATA LIST / ACTIVE TEST



READ DATA LIST

HINT:
Using the intelligent tester's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) and turn the tester ON.

  3. Select the following menu items: Body / Theft Deterrent / Data List.

  4. Check the results by referring to the table below.

    Theft warning ECU: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Hood Courtesy Switch
    Hood courtesy switch / ON or OFF
    ON: Engine hood is open
    OFF: Engine hood is closed
    -
    Key Unlock Warning Switch*
    Unlock warning switch / ON or OFF
    ON: Key is in ignition key cylinder
    OFF: No key is in ignition key cylinder
    -
    IG SW
    Ignition switch on (IG) signal / ON or OFF
    ON: Ignition switch on (ACC, IG) or start
    OFF: Ignition switch off
    -
    Intrusion Sensor OFF
    Intrusion sensor off switch signal / ON or OFF
    ON: Intrusion sensor off switch is ON
    OFF: Intrusion sensor off switch is OFF
    -
    Intrusion Sensor Detection
    Intrusion sensor signal / ON or OFF
    ON: When theft deterrent system function is ON and intrusion sensor signal is ON
    OFF: When theft deterrent system function is ON and intrusion sensor signal is OFF
    -

    HINT:
    *: w/o Entry and start system


    Main body ECU: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Door Courtesy SW
    Driver side door courtesy light switch signal / ON or OFF
    ON: Driver side door is open
    OFF: Driver side door is closed
    -
    D-Door Lock Pos SW
    Driver side door lock position switch signal / ON or OFF
    ON: Driver side door is unlocked
    OFF: Driver side door is locked
    -
    P Door Courtesy SW
    Passenger side door courtesy light switch signal / ON or OFF
    ON: Passenger side door is open
    OFF: Passenger side door is closed
    -
    P-Door Lock Pos SW
    Passenger side door lock position switch signal / ON or OFF
    ON: Passenger side door is unlocked
    OFF: Passenger side door is locked
    -
    RR Door Courtesy SW
    Rear door RH courtesy light switch signal / ON or OFF
    ON: Rear door RH is open
    OFF: Rear door RH is closed
    -
    RL Door Courtesy SW
    Rear door LH courtesy light switch signal / ON or OFF
    ON: Rear door LH is open
    OFF: Rear door LH is closed
    -
    Back Door Courtesy SW
    Back door courtesy light switch signal / ON or OFF
    ON: Back door is open
    OFF: Back door is closed
    -


PERFORM ACTIVE TEST

HINT:
Performing the intelligent tester's Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed during the Active Test.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) and turn the tester ON.

  3. Select the following menu items: Body / Theft Deterrent / Active Test.

  4. Perform the Active Test by referring to the table below.

    Theft warning ECU: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indicator
    Turn security indicator light
    ON or OFF
    -
    Security Horn 2
    Sound theft warning
    ON or OFF
    -

    Main body ECU: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Vehicle Horn
    Sounds vehicle horn
    ON or OFF
    -