ENTRY AND START SYSTEM > Wireless Door Lock Buzzer Does not Sound |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (WIRELESS DOOR LOCK BUZZER) |
Select the Active Test, use the intelligent tester to generate a control command, and then check that the wireless door lock buzzer sounds.
| Item | Test Details | Diagnostic Note |
| Buzzer Resp Sound | Wireless door lock buzzer ON / OFF | - |
|
| ||||
| NG | |
| 2.CHECK WIRE HARNESS (CERTIFICATION ECU - WIRELESS DOOR LOCK BUZZER AND BODY GROUND) |
![]() |
Disconnect the E63 ECU connector.
Disconnect the A13 buzzer connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| BZR (E63-21) - A13-1 | Below 1 Ω |
| A13-2 - Body ground | |
| BZR (E63-21) or A13-1 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT WIRELESS DOOR LOCK BUZZER |
![]() |
Remove the wireless door lock buzzer.
Measure the resistance of the buzzer.
| Tester Connection | Specified Condition |
| 1 - 2 | Approx. 1 kΩ |
|
| ||||
| OK | ||
| ||