Home › BODY › SLIDING ROOF › SLIDING ROOF SYSTEM

SLIDING ROOF SYSTEM > Sliding Roof Control Switch Circuit

for Preparation Click here


DESCRIPTION

If either the sliding function or tilt function does not operate, there may be a malfunction in the sliding roof control switch circuit.

WIRING DIAGRAM


B130068E04


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SLIDING ROOF OPERATION)
  1. Select the Active Test, use the intelligent tester to generate a control command, and then check that the sliding roof operates normally.

    Sliding roof ECU 
    Item
    Test Details
    Diagnostic Note
    Slide Roof
    Operate sliding roof OPEN / DOWN
    OPEN / DOWN: Sliding roof OPEN / DOWN operation occurs
    OFF: Sliding roof is not operating
    -
    Slide Roof
    Operate sliding roof CLOSE / UP
    CLOSE / UP: Sliding roof CLOSE / UP operation occurs
    OFF: Sliding roof is not operating
    -

    OK:
    Sliding roof operates normally.



NG
REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)
OK


2.READ VALUE USING INTELLIGENT TESTER (SLIDING ROOF CONTROL SWITCH)
  1. Use the Data List to check if the sliding roof switch is functioning properly.

    Sliding roof ECU 
    Item
    Measurement Item / Display (Range)
    Normal Condition
    Diagnostic Note
    Close Switch
    Slide switch close signal / ON or OFF
    ON: TILT UP switch is pressed
    OFF: TILT UP switch is not pressed
    -
    Open Switch
    Slide switch open signal / ON or OFF
    ON: SLIDE OPEN switch is pressed
    OFF: SLIDE OPEN switch is not pressed
    -

    OK:
    When the switch is operating, the intelligent tester should display as shown in the table.



OK
REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY
NG


3.CHECK WIRE HARNESS (MAP LIGHT ASSEMBLY - SLIDING ROOF DRIVE GEAR AND BODY GROUND)


    B130118E22
  1. Disconnect the R8 map light connector.

  1. Disconnect the R9 gear connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    R9-7 (DWN) - R8-9 (DOWN)
    Below 1 Ω
    R9-9 (UP) - R8-8 (UP)
    Below 1 Ω
    R8-7 (GND) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE MAP LIGHT ASSEMBLY (SLIDING ROOF CONTROL SWITCH)