SLIDING ROOF SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK AUTO OPERATION |
Turn the ignition switch on (IG).
When the roof glass is fully closed, press the SLIDE OPEN switch for 0.3 seconds or more. Check that the roof glass automatically slides until it is fully opened.
When the roof glass is fully tilted up, press the SLIDE OPEN switch for 0.3 seconds or more. Check that the roof glass automatically slides until it is fully tilted down.
When the roof glass is fully open, press the TILT UP switch for 0.3 seconds or more. Check that the roof glass automatically slides until it is fully closed.
When the roof glass is fully closed, press the TILT UP switch for 0.3 seconds or more. Check that the roof glass automatically slides until it is fully tilted up.
When the auto operation is operating, check that pressing any personal light switch stops the roof glass operation.
| 2. CHECK SLIDING ROOF OPERATION AFTER IGNITION SWITCH IS TURNED OFF |
Turn the ignition switch from on (IG) to off, and check that the sliding roof operates. Then open and close the driver side door once, and check that the sliding roof does not operate.
Turn the ignition switch from on (IG) to off and wait for approximately 45 seconds. Check that the sliding roof does not operate.
Operate the auto (SLIDE OPEN or TILT UP) operation. While the roof glass is in motion, turn the ignition switch from on (IG) to off. Check that the auto operation continues until the roof glass opens or closes fully.
| 3. CHECK JAM PROTECTION FUNCTION |
![]() |
When the sliding roof auto operation is operating and an object is caught between the vehicle body and glass, check that the roof glass opens a distance of 218 mm (8.58 in.) from the point of contact with the object, or opens fully if an opening distance of 218 mm (8.58 in.) is not available.
![]() |
When the TILT UP / DOWN function is operating, and an object is caught between the vehicle body and the roof glass, check that the sliding roof tilts up fully.