WIPER AND WASHER SYSTEM (w/o Rain Sensor) > TERMINALS OF ECU |
| CHECK HEADLIGHT CLEANER CONTROL RELAY |

Disconnect the A44 relay connector.
Measure the voltage and resistance of the wire harness side connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| IG (A44-3) - Body ground | L - Body ground | IG signal circuit | Ignition switch on (IG) | 10 to 14 V |
| Ignition switch off | Below 1 V | |||
| E (A44-4) - Body ground | W-B - body ground | Body ground | Always | Below 1 Ω |
Reconnect the A44 relay connector.
Measure the voltage of the connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| HDLO (A44-1) - Body ground | BR - Body ground | Headlight LO signal | Headlight control switch LO | 10 to 14 V |
| Headlight control switch except LO | Below 1 V | |||
| H (A44-2) - Body ground | R - Body ground | Headlight cleaner switch signal | Headlight cleaner switch ON, headlight control switch LO | 10 to 14 V |
| Headlight cleaner switch ON, headlight control switch except LO | Below 1 V | |||
| PB (A44-6) - Body ground | B - Body ground | Headlight cleaner motor signal | Headlight cleaner switch ON, headlight control switch except LO | 10 to 14 V |
| Headlight cleaner switch ON, headlight control switch LO | Below 1 V |