WIPER AND WASHER SYSTEM (w/ Rain Sensor) > Headlight Cleaner Switch Circuit |

| 1.INSPECT HEADLIGHT CLEANER SWITCH |
![]() |
Remove the headlight cleaner switch.
Measure the resistance of the switch.
| Tester Connection | Switch Condition | Specified Condition |
| 5 - 8 | ON | Below 25 Ω |
| OFF | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (SWITCH - ECU AND RELAY) |

Disconnect the E4 switch connector.
Disconnect the A44 relay connector
Disconnect the E18 ECU connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E4-8 - A44-2 (H) | Below 1 Ω |
| E4-5 - E18-20 (HRLY) |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (RELAY - ECU) |
![]() |
Disconnect the A44 relay connector
Disconnect the E18 ECU connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| A44-1 (HDLO) - E18-20 (HRLY) | Below 1 Ω |
|
| ||||
| OK | ||
| ||