Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER AND WASHER SYSTEM (w/ Rain Sensor)

WIPER AND WASHER SYSTEM (w/ Rain Sensor) > Rain Sensor Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to operate the rain sensor.
The auto wiper system operates when the wiper switch is in the AUTO position.

WIRING DIAGRAM


B129039E02


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (ECU - SENSOR)
E125076E05
  1. Disconnect the E66 ECU connector.

  1. Disconnect the R5*1 or R7*2 sensor connector.

    HINT:
    *1: for LHD
    *2: for RHD

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    for LHD 
    Tester Connection
    Specified Condition
    E66-8 (SIG) - R5-4 (SIG)
    Below 1 Ω
    E66-14 (PA1) - R5-3 (AUTO)
    E66-25 (E) - R5-1 (ES)

    for RHD:
    Tester Connection
    Specified Condition
    E66-8 (SIG) - R7-4 (SIG)
    Below 1 Ω
    E66-14 (PA1) - R7-3 (AUTO)
    E66-25 (E) - R7-1 (ES)



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE