WIPER AND WASHER SYSTEM (w/ Rain Sensor) > Washer Motor Circuit |

| 1.INSPECT FUSE (WSH) |
Remove the WSH fuse from the instrument panel junction block.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 2.INSPECT WINDSHIELD WASHER MOTOR AND PUMP |
![]() |
Remove the washer jar.
Apply battery voltage to the windshield washer motor connector and check the operation of the windshield washer motor assembly.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 2 | Washer fluid flows from washer jar |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (MOTOR - RELAY AND BATTERY) |
![]() |
Disconnect the A41 motor connector.
Disconnect the E66 relay connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Switch Condition | Specified Condition |
| A41-1 - Body ground | Ignition switch on (IG) | 10 to 14 V |
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| A41-2 - E66-4 (W) | Below 1 Ω |
|
| ||||
| OK | ||
| ||