Home › ENGINE ยท 2AD-FHV › ENGINE MECHANICAL › CYLINDER BLOCK

CYLINDER BLOCK > REPLACEMENT

for Preparation Click here



1. REPLACE CYLINDER BLOCK STUD BOLT

NOTICE:
If a stud bolt is deformed or the threads are damaged, replace it.

  1. Remove the stud bolts.

  1. Apply adhesive to the holes for the stud bolts labeled A on the cylinder block. Install new stud bolts labeled A.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



  1. Using an E5 "TORX" socket wrench, install new stud bolts labeled B and C.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



    A203743E01



    A206565
  1. Apply adhesive to the holes for the stud bolts on the crankshaft bearing cap. Install 2 new stud bolts to the crankshaft bearing cap.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



2. REPLACE CYLINDER BLOCK STRAIGHT PIN

NOTICE:
It is not necessary to remove the straight pin unless it is being replaced.

  1. Remove the straight pin.



  1. Using a plastic-faced hammer, tap in a new straight pin to the cylinder block.

    Standard Protrusion:
    Item
    Specified Condition
    Pin A
    11 mm (0.433 in.)
    Pin B
    7.0 mm (0.726 in.)
    Pin C
    18 mm (0.709 in.)
    Pin D
    7.5 mm (0.725 in.)
    Pin E
    7.5 mm (0.725 in.)



    A203745E01



    A206566
  1. Using a plastic-faced hammer, tap in new ring pins to the crankshaft bearing cap.

    Standard protrusion:
    6.5 mm (0.256 in.)