Home › ENGINE ยท 2AD-FHV › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > REPAIR

for Preparation Click here



1. REPAIR INTAKE VALVE SEAT

NOTICE:
Keep the lip free of foreign matter.



    A110502E06
  1. If the seating is too high on the valve face, use 30° and 45° cutters to correct the seat.



    A101380E07
  1. If the seating is too low on the valve face, use 60° and 45° cutters to correct the seat.

  1. Check that the seat contact is in the middle of the valve face and has the following width.

    Standard width:
    1.0 to 1.4 mm (0.0394 to 0.0551 in.)



2. REPAIR EXHAUST VALVE SEAT

NOTICE:
Keep the lip free from foreign matter.



    A110503E05
  1. If the seating is too high on the valve face, use 30° and 45° cutters to correct the seat.



    A101382E04
  1. If the seating is too low on the valve face, use 60° and 45° cutters to correct the seat.

  1. Check that the seat contact is in the middle of the valve face and has the following width.

    Standard width:
    1.0 to 1.4 mm (0.0394 to 0.0551 in.)