Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System)

ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System) > ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to operate the transponder key ECU.

WIRING DIAGRAM


B129962E01


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-B2)
  1. Remove the ECU-B2 fuse from the No. 2 relay block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK WIRE HARNESS (TRANSPONDER KEY ECU - BATTERY AND BODY GROUND)


    B110782E10
  1. Disconnect the E50 ECU connector.

  1. Measure the resistance and voltage of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E50-16 (GND) - Body ground
    Below 1 Ω
    Standard voltage:
    Tester Connection
    Specified Condition
    E50-1 (+B) - Body ground
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE