Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System)

ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System) > Security Indicator Light Circuit

for Preparation Click here


DESCRIPTION

When the transponder key is registered, the transponder key ECU indicates the key registration condition by lighting up, blinking or turning off the security indicator.

WIRING DIAGRAM


B129779E02


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY INDICATOR LIGHT)
  1. Select the Active Test, use the intelligent tester (with CAN VIM) to generate a command, and then check that the security indicator light operation is normal.

    Transponder key ECU: 
    Item
    Normal Condition
    Diagnostic Note
    Security Indic
    Security indicator light turns ON / OFF
    -

    OK:
    Security indicator light turns ON / OFF



OK
Go to step 3
NG


2.CHECK WIRE HARNESS (TRANSPONDER KEY ECU AND BODY GROUND - SECURITY INDICATOR LIGHT)

B129783E04

  1. Disconnect the E50 ECU connector.

  1. Disconnect the E25*1 or E26*2 light connector.

  1. Measure the resistance of the wire harness side connectors.

    HINT:
    *1: for Manual air conditioning system
    *2: for Automatic air conditioning system


    Standard resistance:
    for Manual Air Conditioning System:
    Tester Connection
    Specified Condition
    E50-8 (IND) - E25-8 (SEC)
    Below 1 Ω
    E25-5 (GND) - Body ground
    E50-8 (IND) or E25-8 (SEC) - Body ground
    10 kΩ or higher
    for Automatic Air Conditioning System:
    Tester Connection
    Specified Condition
    E50-8 (IND) - E26-10 (LP)
    Below 1 Ω
    E26-7 (GND) - Body ground
    E50-8 (IND) or E26-10 (LP) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.INSPECT TRANSPONDER KEY ECU (OUTPUT)


    B087039E05
  1. Remove the transponder key ECU with its connectors still connected.

  1. Measure the voltage of the ECU.

    Standard voltage:
    Tester Condition
    Condition
    Specified Condition
    E50-8 (IND) - Body ground
    Engine immobiliser system is set
    11 to 14 V and below 1 V output alternately



NG
REPLACE TRANSPONDER KEY ECU
OK

REPLACE CLOCK SUB-ASSEMBLY (for MANUAL AIR CONDITIONING SYSTEM), HEATER CONTROL PANEL (for AUTOMATIC AIR CONDITIONING SYSTEM)